When.com Web Search

  1. Ad

    related to: pressure in crankcase system

Search results

  1. Results From The WOW.Com Content Network
  2. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    A second function of the PCV valve is to act as a flame arrester and to prevent positive pressure from the intake system from entering the crankcase. This can happen on turbocharged engines or when a backfire takes place, and the positive pressure could damage the crankcase seals and gaskets, or even cause a crankcase explosion. The PCV valve ...

  3. Internal combustion engine - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine

    The reed valve opens when the crankcase pressure is slightly below intake pressure, to let it be filled with a new charge; this happens when the piston is moving upwards. When the piston is moving downwards the pressure in the crankcase increases and the reed valve closes promptly, then the charge in the crankcase is compressed.

  4. Crankcase - Wikipedia

    en.wikipedia.org/wiki/Crankcase

    A crankcase is the housing in a piston engine that surrounds the crankshaft. In most modern engines, the crankcase is integrated into the engine block. Two-stroke engines typically use a crankcase-compression design, resulting in the fuel/air mixture passing through the crankcase before entering the cylinder(s). This design of the engine does ...

  5. Crankcase heater - Wikipedia

    en.wikipedia.org/wiki/Crankcase_heater

    A crankcase heater is an electrical component in a compressor in an air-conditioning system, heat pump system, or chiller system. The crankcase heater is normally on all the time, even when the unit is not running, though temperature sensors and set points may turn it off when not needed.

  6. Component parts of internal combustion engines - Wikipedia

    en.wikipedia.org/wiki/Component_parts_of...

    A supercharger is a "forced induction" system which uses a compressor powered by the shaft of the engine which forces air through the valves of the engine to achieve higher flow. When these systems are employed the maximum absolute pressure at the inlet valve is typically around 2 times atmospheric pressure or more. A cutaway of a turbocharger

  7. MAP sensor - Wikipedia

    en.wikipedia.org/wiki/MAP_sensor

    Thus, a MAP sensor will always read 100 kPa more than a boost sensor measuring the same conditions. A MAP sensor will never display a negative reading because it is measuring absolute pressure, where zero is the total absence of pressure. Vacuum is measured as a negative pressure relative to normal atmospheric pressure. Vacuum-Boost sensors can ...

  8. AOL Mail

    mail.aol.com/m

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Two-stroke power valve system - Wikipedia

    en.wikipedia.org/wiki/Two-stroke_power_valve_system

    As the piston travels upward in the cylinder, it creates low pressure area in the crankcase; this draws fresh air and atomized fuel from the carburetor through a hole in the cylinder wall or directly into the crankcase. As the piston continues travelling upward, transfer ports and the exhaust ports are closed off, thus trapping the combustible ...