When.com Web Search

  1. Ads

    related to: 16 inch wide soffit panels

Search results

  1. Results From The WOW.Com Content Network
  2. Soffit - Wikipedia

    en.wikipedia.org/wiki/Soffit

    A soffit is an exterior architectural feature, generally the horizontal, aloft underside of the roof edge. Its archetypal form, sometimes incorporating or implying the projection of rafters or trusses over the exterior of supporting walls, is the underside of eaves (to connect a supporting wall to projecting edge(s) of the roof ).

  3. Wall stud - Wikipedia

    en.wikipedia.org/wiki/Wall_stud

    Typical dimensions of today's "two by four" is 1.5 by 3.5 inches (38 mm × 89 mm) dimensional lumber prior to sanding and are typically placed 16 inches (406 mm) from each other's center, but sometimes also at 12 inches (305 mm) or 24 inches (610 mm).

  4. Fascia (architecture) - Wikipedia

    en.wikipedia.org/wiki/Fascia_(architecture)

    The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the columns. The guttae or drip edge was mounted on the fascia in the Doric order, below the triglyph

  5. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...

  6. Structural insulated panel - Wikipedia

    en.wikipedia.org/wiki/Structural_insulated_panel

    Typical U.S. height for panels is 8 or 9 feet (2.4 or 2.7 m). Panels come in widths ranging from 4 to 12 inches (100–300 mm) thick and a rough cost is $4–$6/ft 2 in the U.S. [5] In 4Q 2010, new methods of forming radius, sine curve, arches and tubular SIPs were commercialized. Due to the custom nature and technical difficulty of forming and ...

  7. Lenhart Farmhouse - Wikipedia

    en.wikipedia.org/wiki/Lenhart_Farmhouse

    The railing is carved in sections gracefully turning at each landing and finally ending in the attic. The attic flooring is of milled 1-inch oak up 18 inches in width. The floor and ceiling joists are all of milled oak 2 inches × 8 inches and 2 inches × 4 inches, respectively. The porch that was enclosed in c. 1925 is a 9-foot × 18-foot kitchen.