Ads
related to: automotive sensor connectors and adapters for cars- Clearance Sale
Enjoy Wholesale Prices
Find Everything You Need
- Store Locator
Team up, price down
Highly rated, low price
- Men's Clothing
Limited time offer
Hot selling items
- All Clearance
Daily must-haves
Special for you
- Temu Clearance
Countless Choices For Low Prices
Up To 90% Off For Everything
- Sale Zone
Special for you
Daily must-haves
- Clearance Sale
Search results
Results From The WOW.Com Content Network
Mobile device applications allow mobile devices such as cell phones and tablets to display and manipulate the OBD-II data accessed via USB adaptor cables or Bluetooth adapters plugged into the car's OBD II connector. Newer devices on the market are equipped with GPS sensors and the ability to transmit vehicle location and diagnostics data over ...
General Motors implemented both a 5-pin connector and a 12-pin connector, with the 12 pin connector (Packard/Delco/Delphi part number 12020043) being used in the vast majority of GM cars. Lotus implemented a 10-pin connector. The pins are given letter designations in the following layouts (as seen from the front of the vehicle connector):
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
The European versions were equipped with a SAE J1772-2009 inlet as well until the automotive industry settled on the IEC Type 2 “Mennekes” connector as the standard inlet – since all IEC connectors use the same SAE J1772 signaling protocol the car manufacturers are selling cars with either a SAE J1772-2009 inlet or an IEC Type 2 inlet ...
Additionally, many major car manufacturers use their own proprietary vehicle bus standards, or overlay proprietary messages over open protocols such as CAN. J1939 (9 pin) Commercial class vehicles have Type-I or Type-II connectors that support CAN based communication per the SAE J1939 protocol.
The IEC 62196-2 Type 2 connector (sometimes referred to as Mennekes for the German company that designed it) is used for charging electric vehicles using AC power, mainly within Europe, Australia, NZ and many other countries outside of North America. The Type 2 connector was adopted as the EU standard in 2013, with full compliance required by 2025.