Ads
related to: anchors for thin metalamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
1960s-era pitons, including: knifeblades, lost arrows, bugaboos, ring angles, and bongs. A piton (/ ˈ p iː t ɒ n /; also called pin or peg) in big wall climbing and in aid climbing is a metal spike (usually steel) that is driven into a crack or seam in the climbing surface using a climbing hammer, and which acts as an anchor for protecting the climber from falling or to assist progress in ...
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
The anchor must be adequate to resist the maximum tensile load of the guy wires; both the dead load of the tension of the wire and the maximum possible live load due to wind. Since the guy wire exerts its force at an angle, the anchor has both vertical and lateral (horizontal) forces on it.
An anchor is a device, normally made of metal, used to secure a vessel to the bed of a body of water to prevent the craft from drifting due to wind or current.
These anchors typically consist of a thick-walled, steel, tubular shaft filled with scrap metal or concrete and fitted with a conical tip. Steel flukes are often attached to the shaft to improve its hydrodynamic stability and to provide additional frictional resistance against uplift after installation. [1]
Ad
related to: anchors for thin metal