Search results
Results From The WOW.Com Content Network
Taps are normally connected to the water supply by means of a "swivel tap connector", which is attached to the end of the water pipe using a soldered or compression fitting, and has a large nut to screw onto the threaded "tail" of the tap, which hangs down underneath the bath, basin or sink.
Shape the water stream coming out of the faucet spout, to produce a straight and evenly pressured stream; Conserve water and reduce energy costs; Reduce faucet noise; Increase perceived water pressure (often used in homes with low water pressure); sometimes described as a pressure regulator or flow regulator
Flow control valves, a type of automatic control valve, regulate fluid flow by maintaining a predetermined flow rate, independent of variations in system pressure. These valves achieve this using pressure-compensated mechanisms, which automatically adjust the valve opening to ensure a steady flow rate.
The sheet has a solid end and a flow-through end; sliding it from one position to the other opens or stops the flow. Also called sliding blind valve; Outflow valve: regulates flow and pressure, part of cabin pressurization; Pilot valve: regulates flow or pressure to other valves; Petcock, a small shut-off valve
[18]: 61 To reduce flow resistance and solid deposits when the direction of flow is changed, they use a shallow curve with a large radius of curvature. [18]: 61 [19] In addition, a well-designed system will often use two 45° elbows instead of one 90° elbow (even a sweep 90° elbow) to reduce flow disruption as much as possible. [18]: 61
In water distribution systems, water is normally maintained at a significant pressure to enable water to flow from the tap, shower, or other fixture. Water pressure may fail or be reduced when a water main bursts, pipes freeze, or there is unexpectedly high demand on the water system (for example, when several fire hydrants are opened). Reduced ...
A regulating gate or valve controls water flow into the pipes of the outlet works, which discharge downstream into a stilling basin or directly into the river. [2] The inlets of the outlet works may consist of either gates or valves, or be composed of a more primitive system of stoplogs .
When these low flow fixtures first emerged manufactures generally did not make sufficient changes to the design besides reducing the amount of water used. As a result, many early low flow toilets did not remove solid waste very well. However, today there are many low-flow toilets that perform better than the older high flow models. [11]