Search results
Results From The WOW.Com Content Network
The gear ratio also determines the transmitted torque. The torque ratio TR AB of the gear train is defined as the ratio of its output torque to its input torque. Using the principle of virtual work, the gear train's torque ratio is equal to the gear ratio, or speed ratio, of the gear
Crawl ratio is a term used in the automotive world to describe the highest gear ratio that a vehicle is capable of. Note that gear ratio, also known as speed ratio, of a gear train is defined as the ratio of the angular velocity of the input gear to the angular velocity of the output gear, and thus a higher gear ratio implies a larger speed reduction, i.e. the input speed is reduced more at ...
Constant speed drive for Boeing 727, made by Sundstrand Corporation. A constant speed drive (CSD) also known as a constant speed generator, is a type of transmission that takes an input shaft rotating at a wide range of speeds, delivering this power to an output shaft that rotates at a constant speed, despite the varying input.
And, if the output gear has fewer teeth than the input gear, then the gear train reduces the input torque. If the output gear of a gear train rotates more slowly than the input gear, then the gear train is called a speed reducer (Force multiplier). In this case, because the output gear must have more teeth than the input gear, the speed reducer ...
When the output disk is adjusted to a position equal to its own radius, the resulting drive ratio is 1:1. The drive ratio can be set to infinity (i.e. a stationary output disk) by moving the output disk to the center of the input disk. The output direction can also be reversed by moving the output disk past the center of the input disk.
A mechanical calculator, ... then moving at a constant speed, and stopping. ... a nine-ratio "preselector transmission" with its output spur gear at the top of the ...
This means the output shaft rotates at the same speed as the selected gear, thus determining the gear ratio of the transmission. [16] The dog clutch is a sliding selector mechanism that sits around the output shaft. It has teeth to fit into the splines on the shaft, forcing that shaft to rotate at the same speed as the gear hub. However, the ...
Toothed belt drives are designed to limit this issue by operating at a constant pitch radius [11]). Chains are often narrower than belts, and this can make it easier to shift them to larger or smaller gears in order to vary the gear ratio. Multi-speed bicycles with derailleurs make use of this. Also, the more positive meshing of a chain can ...