Ads
related to: wire lath for concrete
Search results
Results From The WOW.Com Content Network
Self-furring lath is an expanded metal lath which is dimpled to hold itself off from a solid surface; Wire lath is made from welded or woven wires and is similar to hardware cloth; Paper backed wire lath is wire lath with building paper attached; Strip laths is metal lath that is several inches wide and is often used to reinforce joints and on ...
Stucco can be applied on construction materials such as metal, expanded metal lath, concrete, cinder block, or clay brick and adobe for decorative and structural purposes. [ 2 ] In English, "stucco" sometimes refers to a coating for the outside of a building and " plaster " to a coating for interiors.
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.
In construction, chicken wire or hardware cloth is used as a metal lath to hold cement or plaster, a process known as stuccoing. Concrete reinforced with chicken wire or hardware cloth yields ferrocement , a versatile construction material.
Expanded metal lath used to support stucco (1919) Facade made from expanded metal. Expanded metal is frequently used to make fences, walkways, and grates, as the material is very durable and strong, unlike lighter and less expensive [dubious – discuss] wire mesh. The many small openings in the material allow flow through of air, water, and ...
The wood pieces labeled "beveled nailing strips" act as screed rails in this installation of a screed coating on Hy-Rib brand wire lath.. A weep screed or sill screed is a screed rail which has drainage holes to allow moisture which penetrated an exterior plaster or stucco coating to drain through the screed.
Formstone is applied in three layers, anchored by a perforated metal lath attached to the underlying brick with nails. [3] Galvanized mesh was used in many instances to reduce the likelihood of rusting. The three layers are cement-based concrete. The first layer of cement mortar is 3/8” to 3/4” thick and it is scored before it dries.
In some cases, with fireproof ceilings, for instance, the metal lathing are hung up with wire hangers so as to allow a space of several inches between the soffit of the concrete floor and the ceiling. For partitions metal laths are grouted in with semi-fluid plaster.