Ad
related to: sterling l2a3 receiver tube
Search results
Results From The WOW.Com Content Network
The Sterling submachine gun is a British submachine gun (SMG). It was tested by the British Army in 1944–1945, but did not start to replace the Sten until 1953. A successful and reliable design, it remained standard issue in the British Army until 1994, [18] when it began to be replaced by the L85A1, a bullpup assault rifle.
The Sterling Engineering Company Ltd was an arms manufacturer based in Dagenham, famous for manufacturing the Sterling submachine gun (L2A3), ArmaLite AR-18 and Sterling SAR-87 assault rifles and parts of Jaguar cars. The company went bankrupt in 1988.
A Sterling L2A3 (Mark 4) submachine gun.ROF Fazakerley manufactured 164,000 Sterlings between 1956 and 1960, after which production of the weapon ended permanently. ROF Fazakerley was a Royal Ordnance Factory rifle manufacturing plant in Fazakerley, Liverpool, which manufactured small arms such as the Sten and Sterling [1] [2] [3] submachine guns and Lee–Enfield rifle during and after World ...
The CETME C2 (also named the CB-64,) is a Spanish submachine gun based on the British Sterling L2A3. It is an open-bolt, blowback-operated firearm that fires the 9×23mm Largo and 9×19mm Parabellum pistol cartridge.
The serial number that was recorded by the Naval History and Heritage Command - UF57A5347 - indicates that this particular weapon was actually manufactured by ROF Fazakerley rather than Sterling. A Sterling-produced weapon would have a serial number beginning with "US" if intended for the British military, or with "KR" (pre-1972) or "S" (post ...
A bullpup conversion of the AR-15 was previously considered but the buffer tube in stock prevented the idea from reaching fruition. [ 11 ] Technically, in the mid-1970s, the 4.85×49mm round was seen as superior to the then existing version of 5.56mm M193 round in use by the US (for the M16/M16A1 ) and by other forces.
A high vacuum tube needs a gridleak resistor parallel to the gridleak capacitor. In Fig. 3, the LC circuit L and C select the receiver frequency. C2 is the gridleak capacitor and helps to demodulate the received signal. B1 is the A-battery or heater battery and B2 is the B-battery or anode battery. In Fig. 8, L, C, B1 and B2 are as in Fig. 3.
In the 1950s a 5-element system (Russian: Государственный Стандарт "State standard" ГОСТ/GOST 5461–59, later 13393–76) was adopted in the (then) Soviet Union for designating receiver vacuum tubes.