Ads
related to: how to measure hydraulic head for air compressor kit
Search results
Results From The WOW.Com Content Network
A hydraulic compressor is a means of compressing air using hydraulic energy. There are two very different types of machines referred to as hydraulic compressors. One type is a mechanical air compressor that is driven by a hydraulic motor. It is a method of converting hydraulic power to pneumatic power. [1]
Measuring hydraulic head in an artesian aquifer, where the water level is above the ground surface. Hydraulic head or piezometric head is a specific measurement of liquid pressure above a vertical datum. [1] [2] It is usually measured as a liquid surface elevation, expressed in units of length, at the entrance (or bottom) of a piezometer.
In fluid dynamics, total dynamic head (TDH) is the work to be done by a pump, per unit weight, per unit volume of fluid. TDH is the total amount of system pressure, measured in feet, where water can flow through a system before gravity takes over, and is essential for pump specification.
In a hydraulic circuit, net positive suction head (NPSH) may refer to one of two quantities in the analysis of cavitation: The Available NPSH (NPSH A): a measure of how close the fluid at a given point is to flashing, and so to cavitation. Technically it is the absolute pressure head minus the vapour pressure of the liquid.
Pressure head is a component of hydraulic head, in which it is combined with elevation head. When considering dynamic (flowing) systems, there is a third term needed: velocity head. Thus, the three terms of velocity head, elevation head, and pressure head appear in the head equation derived from the Bernoulli equation for incompressible fluids:
The meter is "read" as a differential pressure head in cm or inches of water and is equivalent to the difference in velocity head. The dynamic pressure, along with the static pressure and the pressure due to elevation, is used in Bernoulli's principle as an energy balance on a closed system .