Ads
related to: end switch on actuator
Search results
Results From The WOW.Com Content Network
After receiving an operation command, the actuator moves the valve in direction OPEN or CLOSE. When reaching the end position, an automatic switch-off procedure is started. Two fundamentally different switch-off mechanisms can be used. The controls switch off the actuator as soon as the set tripping point has been reached. This is called limit ...
Even though the flat spring unflexes as it moves downward, the switch is designed so the net effect is acceleration. This "over-center" action produces a very distinctive clicking sound and a very crisp feel. In the actuated position the curved spring provides some upward force. If the actuator is released this will move the flat spring upward.
They can determine the presence, passing, positioning, and end of travel of an object. They were first used to define the limit of travel of an object, hence the name "limit switch". Standardized limit switches are industrial control components manufactured with a variety of operator types, including lever, roller plunger, and whisker type.
An actuator is a component of a machine that produces force, torque, or displacement, when an electrical, pneumatic or hydraulic input is supplied to it in a system (called an actuating system). The effect is usually produced in a controlled way. [1] An actuator translates such an input signal into the required form of mechanical energy.
Two rotary actuators on opposite ends of the rotary snap-switch shaft, can advance or reverse the switch position. The rotary solenoid has a similar appearance to a linear solenoid, except that the armature core is mounted in the center of a large flat disk, with three inclined raceways coined into the underside of the disk.
The motor may be attached to the end of the actuator. The drive motor is of typical construction with a solid drive shaft that is geared to the drive nut or drive screw of the actuator. Compact linear actuators use specially designed motors that try to fit the motor and actuator into the smallest possible shape.