When.com Web Search

  1. Ads

    related to: pin diode as switch in parallel plate system

Search results

  1. Results From The WOW.Com Content Network
  2. PIN diode - Wikipedia

    en.wikipedia.org/wiki/PIN_diode

    A PIN diode RF microwave switch. Under zero- or reverse-bias (the "off" state), a PIN diode has a low capacitance. The low capacitance will not pass much of an RF signal. Under a forward bias of 1 mA (the "on" state), a typical PIN diode will have an RF resistance of about 1 ohm, making it a good conductor of RF. Consequently, the PIN diode ...

  3. Radio-frequency microelectromechanical system - Wikipedia

    en.wikipedia.org/wiki/Radio-frequency_micro...

    The prior art in passive electronically scanned arrays, includes an X-band continuous transverse stub (CTS) array fed by a line source synthesized by sixteen 5-bit reflect-type RF MEMS phase shifters based on ohmic cantilever RF MEMS switches, [27] [28] an X-band 2-D lens array consisting of parallel-plate waveguides and featuring 25,000 ohmic ...

  4. Diode - Wikipedia

    en.wikipedia.org/wiki/Diode

    A PIN diode has a central un-doped, or intrinsic, layer, forming a p-type/intrinsic/n-type structure. [42] They are used as radio frequency switches and attenuators. They are also used as large-volume, ionizing-radiation detectors and as photodetectors. PIN diodes are also used in power electronics, as

  5. Power semiconductor device - Wikipedia

    en.wikipedia.org/wiki/Power_semiconductor_device

    In fact, any power semiconductor relies on a PIN diode structure in order to sustain voltage; this can be seen in figure 2. The power MOSFET has the advantages of a majority carrier device, so it can achieve a very high operating frequency, but it cannot be used with high voltages; as it is a physical limit, no improvement is expected in the ...

  6. Gate turn-off thyristor - Wikipedia

    en.wikipedia.org/wiki/Gate_turn-off_thyristor

    GTO thyristors suffer from long switch-off times, whereby after the forward current falls, there is a long tail time where residual current continues to flow until all remaining charge from the device is taken away. This restricts the maximum switching frequency to about 1 kHz. It may be noted, however, that the turn-off time of a GTO is ...

  7. DIN 72552 - Wikipedia

    en.wikipedia.org/wiki/DIN_72552

    hazard lights switch 85c hazard sound on Switches 81 opener 81a 1 out 81b 2 out 82 lock in 82a 1st out 82b 2nd out 82z 1st in 82y 2nd in 83 multi position switch, in 83a out position 1 83b out position 2 Relay; 85 relay coil - Important if relay coil has flyback diode in parallel 86 relay coil + Important if relay coil has diode in parallel