Search results
Results From The WOW.Com Content Network
Larger primary devices (and transitions) that do not readily fit into a standard 4 ft (1.2 m) precast manhole barrel, either a larger barrel or a concrete vault must be used which adds cost. Packaged metering manholes, on the other hand, can integrate primary devices that are larger than the manhole barrel – with any portion that doesn't fit ...
The purpose of the cone section is to reduce the openings from large chamber sizes to small cover sizes. In a masonry manhole, the bricks form a corbel inward to reduce the opening to a desired size. [14] In precast concrete, the cone section comes in two forms, concentric and eccentric. In a concentric cone section, the top opening is in the ...
The ISO-standard ISO 15398 regulates the minimum requirements, proofs of suitability and auditing standards for manhole covers made of thermoplastics. The complete title of the norm is Specification for thermoplastics covers and frames for manholes and inspection chambers used in non-traffic areas. Issue date: 1. December 2012. The norm is in ...
A round manhole and its cover. A manhole cover is a removable plate forming the lid over the opening of a manhole, an opening large enough for a person to pass through that is used as an access point for an underground vault or pipe. It is designed to prevent anyone or anything from falling in, and to keep out unauthorized persons and material.
The larger line enters from the right and changes direction within the manhole to exit from the top of the photo. A smaller line enters from the bottom of the photo under the access steps. The concrete floor of the manhole has channels to minimize accumulation of solids. Interior of a large sanitary sewer viewed from an access manhole chamber.
The configuration (size, position and quantity) of this reinforcement should be supplemented to the element reinforcement design to ensure for adequate capacity of the lifting design. Lifting design is influenced by the steel / concrete interaction of the specific anchor selected. Different load cases are considered by the lifting design ...
Manhole closings are protected by a grating or manhole cover, a flat plug designed to prevent accidental or unauthorized access to the manhole. These covers are traditionally made of metal, [2] but may be constructed from precast concrete, glass reinforced plastic or other composite materials (especially where cover theft is of concern ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...