When.com Web Search

  1. Ads

    related to: 240 volt garage heater wiring diagram 04 sienna le mass air flow sensor oem

Search results

  1. Results From The WOW.Com Content Network
  2. Mass flow sensor - Wikipedia

    en.wikipedia.org/wiki/Mass_flow_sensor

    A mass (air) flow sensor (MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine. The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its density with temperature and pressure.

  3. Electrical wiring in North America - Wikipedia

    en.wikipedia.org/wiki/Electrical_wiring_in_North...

    In 240-volt applications not requiring a neutral conductor, the white wire may be used as the second hot conductor, but must be recolored with tape or by some other method. [ citation needed ] Four-wire flexible equipment connection cords have red as the fourth color; unlike older European practices, color-coding in flexible cords is the same ...

  4. Split-phase electric power - Wikipedia

    en.wikipedia.org/wiki/Split-phase_electric_power

    The line to neutral voltage is half the line-to-line voltage. Lighting and small appliances may be connected between a line wire and the neutral. Higher-power appliances, such as cooking equipment, space heating, water heaters, clothes dryers, air conditioners and electric vehicle charging equipment, are connected to the two line conductors.

  5. NEMA connector - Wikipedia

    en.wikipedia.org/wiki/NEMA_connector

    All NEMA 6 devices are three-wire grounding devices (hot-hot-ground) used for 208 and 240 V circuits and rated for 250 V maximum, with the 6-15, 6-20 and 6-30 being grounding versions of the 2-15, 2-20 and 2-30, respectively. The 6-15 resembles the 5-15, but with collinear horizontal pins, spaced 23 ⁄ 32 in (18.3 mm) center-to-center. The 20 ...

  6. High-leg delta - Wikipedia

    en.wikipedia.org/wiki/High-leg_delta

    So if A–B, B–C and C–A are all 240 volts, then A–N and C–N will both be 120 volts, but B–N will be 208 volts. Other types of three-phase supplies are wye connections, ungrounded delta connections, or corner-grounded delta [2] (ghost leg configuration) connections. These connections do not supply split single-phase power, and do not ...

  7. Toyota Sienna - Wikipedia

    en.wikipedia.org/wiki/Toyota_Sienna

    The Sienna debuted with a 3.0-liter 1MZ-FE V6 engine rated at 194 hp (145 kW) and 209 lb⋅ft (284 N⋅m) of torque. Built on an extended platform of the XV20 Toyota Camry, the Sienna was appropriately marketed as the "Camry of minivans," capitalizing on the Camry's popularity and reputation. It came in three trim levels: CE, LE, and XLE.

  8. Heated air inlet - Wikipedia

    en.wikipedia.org/wiki/Heated_air_inlet

    These vehicles have a MAF sensor, Air Temperature sensor, and when equipped with the 2.3L 4-cylinder, two spark-plugs per cylinder. This combination ensures the air is just warm enough to vaporize the droplets and does very noticeably improve performance and emissions at the same time in cold, northern winter weather. [citation needed]

  9. Ground and neutral - Wikipedia

    en.wikipedia.org/wiki/Ground_and_neutral

    This practice arose from the three-wire system used to supply both 120 volt and 240 volt loads. Because these listed appliances often have components that use either 120, or both 120 and 240 volts, there is often some current on the neutral wire. This differs from the protective grounding wire, which only carries current under fault conditions.