Ads
related to: chuck for woodturning lathe tools kit harbor freightamazon.com has been visited by 1M+ users in the past month
northerntool.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
Lathes and hand tools The Holtzapffel dynasty of tool and lathe makers was founded in Long Acre , London by a Strasbourg-born turner, Jean-Jacques Holtzapffel, [ 1 ] in 1794. The firm specialized in lathes for ornamental turning but also made a name for its high-quality edge and boring tools.
A lathe faceplate is a basic workholding accessory for a wood or metal turning lathe. It is a circular metal (usually cast iron) plate which fixes to the end of the lathe spindle. The workpiece is then clamped to the faceplate, typically using t-slot nuts in slots in the faceplate, or less commonly threaded holes in the faceplate itself.
Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.
For spindle turning, the wood is held on the lathe either by both ends (between the headstock and tailstock) or by one end only using a lathe chuck [2]. Wood is generally removed by running a turning tool down the slope of the wood from a larger diameter in the wood to a smaller diameter.
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
Ads
related to: chuck for woodturning lathe tools kit harbor freightamazon.com has been visited by 1M+ users in the past month