When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Piping and instrumentation diagram - Wikipedia

   en.wikipedia.org/wiki/Piping_and_instrumentation...

   A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process. In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on ...

3. Pressure regulator - Wikipedia

   en.wikipedia.org/wiki/Pressure_regulator

   A back-pressure regulator, back-pressure valve, pressure sustaining valve or pressure sustaining regulator is a control valve that maintains the set pressure at its inlet side by opening to allow flow when the inlet pressure exceeds the set value. It differs from an over-pressure relief valve in that the over-pressure valve is only intended to ...

4. Proportional–integral–derivative controller - Wikipedia

   en.wikipedia.org/wiki/Proportional–integral...

   Pressure control provided only a proportional control that, if the control gain was too high, would become unstable and go into overshoot with considerable instability of depth-holding. The pendulum added what is now known as derivative control, which damped the oscillations by detecting the torpedo dive/climb angle and thereby the rate-of ...

5. ANSI device numbers - Wikipedia

   en.wikipedia.org/wiki/ANSI_device_numbers

   In electric power systems and industrial automation, ANSI Device Numbers can be used to identify equipment and devices in a system such as relays, circuit breakers, or instruments. The device numbers are enumerated in ANSI / IEEE Standard C37.2 Standard for Electrical Power System Device Function Numbers, Acronyms, and Contact Designations.

6. ISO 10628 - Wikipedia

   en.wikipedia.org/wiki/ISO_10628

   ISO 10628. ISO 10628 Diagrams for the chemical and petrochemical industry specifies the classification, content, and representation of flow diagrams. It does not apply to electrical engineering diagrams. ISO 10628 consists of the following parts: Part 1: Specification of Diagrams (ISO 10628-1:2014) [1] Part 2: Graphical Symbols (ISO 10628-2:2012)

7. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with ...