Search results
Results From The WOW.Com Content Network
Peak-to-peak amplitude (abbreviated p–p or PtP or PtoP) is the change between peak (highest amplitude value) and trough (lowest amplitude value, which can be negative). With appropriate circuitry, peak-to-peak amplitudes of electric oscillations can be measured by meters or by viewing the waveform on an oscilloscope .
By definition, it is the amount of energy gained by the charge of a single electron moved across an electric potential difference of one volt. electronegativity A chemical property that describes the tendency of an atom or a functional group to attract electrons (or electron density) towards itself. electronics
A fanfare (or fanfarade or flourish) is a short musical flourish which is typically played by trumpets (including fanfare trumpets), French horns or other brass instruments, often accompanied by percussion. [1]
Amplitude is a measure of a periodic variable in classical physics. Amplitude may also refer to: In mathematics and physics. Jacobi amplitude of Jacobi ...
Different fields of application have different definitions for the term. All the meanings are very similar in concept: In chemistry, the transmission coefficient refers to a chemical reaction overcoming a potential barrier; in optics and telecommunications it is the amplitude of a wave transmitted through a medium or conductor to that of the incident wave; in quantum mechanics it is used to ...
The power gain can be calculated using voltage instead of power using Joule's first law = /; the formula is: = . In many cases, the input impedance and output impedance are equal, so the above equation can be simplified to:
In other words, it is the width of a spectrum curve measured between those points on the y-axis which are half the maximum amplitude. Half width at half maximum (HWHM) is half of the FWHM if the function is symmetric. The term full duration at half maximum (FDHM) is preferred when the independent variable is time.
The reason IRE is a relative measurement (percent) is because a video signal may be any amplitude. This unit is used in the ITU recommendations BT.470 and BT.1700 which define PAL, NTSC and SECAM: [7] [8] [9]