Search results
Results From The WOW.Com Content Network
The main disadvantage of this coupling method is that it causes some loss for the low frequency signals. However, for amplifying signals of frequencies greater than 10 Hz, this coupling is the best and least expensive method. It is usually applied in small signal amplifiers, such as in record players, tape recorders, radio receivers, etc.
Coupling can be deliberate as part of the function of the circuit, or it may be undesirable, for instance due to coupling to stray fields. For example, energy is transferred from a power source to an electrical load by means of conductive coupling , which may be either resistive or direct coupling .
In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21. Splitter and combiner networks used with amplifiers to produce a high power 40 dB (voltage gain 100) solid state amplifier Figure 22. Phase arrangement on a hybrid power combiner.
A direct-coupled amplifier [1] or DC amplifier is a type of amplifier in which the output of one stage of the amplifier is coupled to the input of the next stage in such a way as to permit signals with zero frequency, also referred to as direct current, to pass from input to output. This is an application of the more general direct coupling.
Amplifiers are sometimes classified by the coupling method of the signal at the input, output, or between stages. Different types of these include: Resistive-capacitive (RC) coupled amplifier, using a network of resistors and capacitors By design these amplifiers cannot amplify DC signals as the capacitors block the DC component of the input ...
Conversely, a voltage follower inserted between a small load resistance and a driving stage presents a large load to the driving stage—an advantage in coupling a voltage signal to a small load. This configuration is commonly used in the output stages of class-B and class-AB amplifiers. The base circuit is modified to operate the transistor in ...
Here the internal units or portions of the op-amp (like the input stage, voltage gain stage, and output stage) will be direct coupled and will also be used to set up the bias conditions inside the op-amp (the input stage will also supply the input bias to the voltage gain stage, for example). However, when two op-amps are directly coupled the ...
Background: The output coupling method of a vacuum tube amplifier generally serves two basic purposes: Negation (blocking) of high DC voltages in the output section to prevent a damaging flow of direct electric current through the loudspeaker.