Search results
Results From The WOW.Com Content Network
This is the only type of static compression that liquids and gases can bear. [3] It affects the volume of the material, as quantified by the bulk modulus and the volumetric strain. The inverse process of compression is called decompression, dilation, or expansion, in which the object enlarges or increases in volume.
The vector T may be regarded as the sum of two components: the normal stress (compression or tension) perpendicular to the surface, and the shear stress that is parallel to the surface. If the normal unit vector n of the surface (pointing from Q towards P ) is assumed fixed, the normal component can be expressed by a single number, the dot ...
Tension is the pulling or stretching force transmitted axially along an object such as a string, rope, chain, rod, truss member, or other object, so as to stretch or pull apart the object. In terms of force, it is the opposite of compression. Tension might also be described as the action-reaction pair of forces acting at each end of an object.
In mechanics, compressive strength (or compression strength) is the capacity of a material or structure to withstand loads tending to reduce size (compression). It is opposed to tensile strength which withstands loads tending to elongate, resisting tension (being pulled apart).
The strength of materials is determined using various methods of calculating the stresses and strains in structural members, such as beams, columns, and shafts. The methods employed to predict the response of a structure under loading and its susceptibility to various failure modes takes into account the properties of the materials such as its yield strength, ultimate strength, Young's modulus ...
When an object is subjected to a force in a single direction (referred to as a uniaxial compression), the compressive stress is determined by dividing the applied force by the cross-sectional area of the object. [1] Consequently, compressive stress is expressed in units of force per unit area. Axial Stress
If the section is symmetric, isotropic and is not curved before a bend occurs, then the neutral axis is at the geometric centroid of a beam or shaft. All fibers on one side of the neutral axis are in a state of tension, while those on the opposite side are in compression.
When the forces are collinear (aligned with each other), they are called tension forces or compression forces. Shear force can also be defined in terms of planes: "If a plane is passed through a body, a force acting along this plane is called a shear force or shearing force." [1]