Search results
Results From The WOW.Com Content Network
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
A chain pump is a type of water pump that uses a chain to move water from one place to another. It works on the principle of a continuous loop of chain moving through a series of sprockets, with attached buckets that lift water as the chain passes over the top sprocket and discharge it as the chain reaches the bottom. [12]
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
Butch, femme, drag, camp, zhuzh and more are now in common parlance, thanks to Polari, as well as some quite spicy terms, like cherry, dish and more (but more on that later).
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...
The device uses the water hammer effect to develop pressure that lifts a portion of the input water that powers the pump to a point higher than where the water started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower, and a need for pumping water to a destination higher in elevation than ...
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...