Search results
Results From The WOW.Com Content Network
Breech-loading firearm that belonged to Philip V of Spain, made by A. Tienza, Madrid circa 1715. It came with a ready-to-load reusable cartridge. This is a miquelet system. Mechanism of Philip V's breech-loading firearm (detail) The breech mechanism of the Ferguson rifle. Breech-loading firearms are known from the 16th century.
A break action is a type of firearm where the barrel(s) are hinged and can be "broken open" to expose the breech. Multi-barrel break action firearms are usually subdivided into over-and-under or side-by-side configurations for two barrel configurations or "combination gun" when mixed rifle and shotgun barrels are used.
A muzzleloader is any firearm in which the user loads the projectile and the propellant charge into the muzzle end of the gun (i.e., from the forward, open end of the gun's barrel). This is distinct from the modern designs of breech-loading firearms, in which user loads the ammunition into the breech end of the barrel. The term "muzzleloader ...
RML 2.5-inch mountain gun United Kingdom: 1879 73: 2.9-inch Parrott rifle United States: 1860 76: 3-inch ordnance rifle United States: 1862 76: RML 7-pounder mountain gun United Kingdom: 1873 86: Canon de campagne de 4 rayé France: 1858 96: Wiard rifle United States: 1861 121: Canon de 12 La Hitte France: 1859 140: 70-pounder Whitworth naval ...
Rotating the crank opens the breech of the weapon, allowing for loading. The use of paper cartridges — a pre-measured amount of gunpowder and a lead bullet wrapped in paper — also sped up the rate of fire. While not as fast as more modern rifles, which use fixed cartridges, the kammerlader was much faster than contemporary muzzle-loading ...
With the muzzle facing upwards, laterally rotating the trigger guard approximately 155° to the right and back deposited a ball and load of powder in the breech and cocked the gun (or wound the wheel if the gun was a wheellock). [6] [23] On some guns a small trigger had to be depressed before rotating the trigger guard.
Close-up of an IOF 32 break-action revolver. The first break-action revolver was patented in France and Britain at the end of December in 1858 by Devisme. [1] A substantial hinge pin joins the two parts of the rifle or shotgun; the stock with its firing mechanism and the fore-piece and barrel, which hold the round to be fired.
While standard rifle barrels taper from breech to muzzle, high precision rifles will often use a barrel with far less taper, called a heavy barrel, sometimes leaving the barrel cylindrical all the way to the muzzle, called a bull barrel. Either technique greatly increases the stiffness of the barrel by enlarging the average diameter, but this ...