When.com Web Search

  1. Ads

    related to: utility trailer tie down anchors

Search results

  1. Results From The WOW.Com Content Network
  2. Tie down strap - Wikipedia

    en.wikipedia.org/wiki/Tie_down_strap

    A ratchet tie-down strap. A tie down strap (also known as a ratchet strap, a lashing strap or a tie down) is a fastener used to hold down cargo or equipment during transport. Tie down straps are essentially webbing that is outfitted with tie down hardware. This hardware allows the tie down strap to attach to the area surrounding the cargo or ...

  3. D-ring - Wikipedia

    en.wikipedia.org/wiki/D-ring

    A D-ring used to secure cargo in a utility trailer (A) D-ring (shown in isometric view) (B) Weld-on pivot link; note the incorrect fillet weld call-out (bottom-right). The correct method of securing a weld-on pivot link is a [t weld] which consists of a perpendicular vee butt joint secured to the billet using a butt weld or fusion weld.

  4. Tie rod - Wikipedia

    en.wikipedia.org/wiki/Tie_rod

    A tie rod or tie bar (also known as a hanger rod if vertical) is a slender structural unit used as a tie and (in most applications) capable of carrying tensile loads only. It is any rod or bar-shaped structural member designed to prevent the separation of two parts, as in a vehicle. Tie rods and anchor plates in the ruins of Coventry Cathedral

  5. Trailer (vehicle) - Wikipedia

    en.wikipedia.org/wiki/Trailer_(vehicle)

    A utility trailer is a general purpose trailer designed to by towed by a light vehicle and to carry light, compact loads of up to a few metric tonnes. It typically has short metal sides (either rigid or folding) to constrain the load, and may have cage sides, and a rear folding gate or ramps. Utility trailers do not have a roof.

  6. Tie down hardware - Wikipedia

    en.wikipedia.org/wiki/Tie_down_hardware

    Tie down hardware used on a transmitter tower in Mullaghanish, Ireland. Tie down hardware is used to turn webbing into a tie down strap . There are various categories of tie down strap hardware that allow for the creation of a virtually unlimited number of different types of tie down straps.

  7. Twistlock - Wikipedia

    en.wikipedia.org/wiki/Twistlock

    The female part of the connector is the 7×7× 4 + 1 ⁄ 2 in (180×180×110 mm) corner casting, which forms each of the eight corners, welded to the container itself, and has no moving parts, only an oval hole in the tops of the four upper corners, and in the bottom of the four lower corners.