When.com Web Search

  1. Ads

    related to: dana 60 axle width chart explained

Search results

  1. Results From The WOW.Com Content Network
  2. Dana 60 - Wikipedia

    en.wikipedia.org/wiki/Dana_60

    The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.

  3. Dana 70 - Wikipedia

    en.wikipedia.org/wiki/Dana_70

    The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60 .

  4. Dodge M-series chassis - Wikipedia

    en.wikipedia.org/wiki/Dodge_M-Series_Chassis

    M-series chassis use a Dana 60 or 70 or Spicer M70 solid rear axles with leaf springs. Frames were used by Winnebago , Champion , Apollo MotorHomes and several other RV manufacturers. The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [ 1 ] M-500, and M-600 depending on the application.

  5. Sterling 10.5 axle - Wikipedia

    en.wikipedia.org/wiki/Sterling_10.5_axle

    The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.

  6. Dana 50 - Wikipedia

    en.wikipedia.org/wiki/Dana_50

    The TTB Dana 50 was also used selectively in the F-350 from 1980 to 1986. The GVW was lower in a F-350 with a TTB Dana 50, than a F-350 with a solid axle. The GAWR of a TTB Dana 50 was 4600 lbs. The Dana 50 TTB spindles will accept the Dana 60 hubs however the knuckles are not interchangeable. All Dana 50 TTB axles were leaf sprung axles.

  7. Dana 80 - Wikipedia

    en.wikipedia.org/wiki/Dana_80

    The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.

  8. Category:Automobile axles - Wikipedia

    en.wikipedia.org/wiki/Category:Automobile_axles

    Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Dana 60; Dana 70; Dana 80; Dana S 110; F. Ford 8.8 axle;

  9. Dana 44 - Wikipedia

    en.wikipedia.org/wiki/Dana_44

    The Dana/Spicer Model 44 is an automotive axle manufactured by Dana Holding Corporation and is used extensively among automobile manufacturers and in the automotive aftermarket area as well. The Dana 44 was first manufactured in the 1940s [ 1 ] and is still being manufactured today, both front and rear axle variants.