Ads
related to: dana 60 axle width chart explained
Search results
Results From The WOW.Com Content Network
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60 .
For the front axle of 4×4 Rams, a Dana 44 was used on all 1500s and the early (light-duty) 2500s. However, most of the 2500 and all 3500 Rams use Dana 60 front axles. The 1500s and some early light-duty 2500s used a 9.25 Chrysler (Spicer) axle in the rear. A Dana 60 rear axle was used on heavy-duty 2500s with the 5.9L V8.
M-series chassis use a Dana 60 or 70 or Spicer M70 solid rear axles with leaf springs. Frames were used by Winnebago , Champion , Apollo MotorHomes and several other RV manufacturers. The line was offered in four ratings, M-300, M-375 (also known as M-400 between 1969–1973), [ 1 ] M-500, and M-600 depending on the application.
The Sterling 10.5 axle is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1985 Ford trucks. The axle was developed to replace the Dana 60 and Dana 70. The Sterling 10.5 axle is currently only made as a full floating axle.
Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Dana 60; Dana 70; Dana 80; Dana S 110; F. Ford 8.8 axle;
The TTB Dana 50 was also used selectively in the F-350 from 1980 to 1986. The GVW was lower in a F-350 with a TTB Dana 50, than a F-350 with a solid axle. The GAWR of a TTB Dana 50 was 4600 lbs. The Dana 50 TTB spindles will accept the Dana 60 hubs however the knuckles are not interchangeable. All Dana 50 TTB axles were leaf sprung axles.
For 1990, the R/V series was reduced in size for a second time, as the 2500-series 3 ⁄ 4-ton trucks and regular cab trucks were discontinued. 1-ton crew-cab, bonus-cab pickups, and 4 door chassis cabs continued in production by Janesville, as the new GMT400 line had lacked a true crew cab since its introduction. Full-size SUVs continued to be ...