Ads
related to: effluent pressure for oil cracking engine problems treatment
Search results
Results From The WOW.Com Content Network
The feedstock to the FCC conversion process usually is heavy gas oil (HGO), which is that portion of the petroleum (crude oil) that has an initial boiling-point temperature of 340 °C (644 °F) or higher, at atmospheric pressure, and that has an average molecular weight that ranges from about 200 to 600 or higher; heavy gas oil also is known as ...
Steam cracking is a petrochemical process in which saturated hydrocarbons are broken down into smaller, often unsaturated, hydrocarbons. It is the principal industrial method for producing the lighter alkenes (or commonly olefins ), including ethene (or ethylene ) and propene (or propylene ).
A delayed coker is a type of coker whose process consists of heating a residual oil feed to its thermal cracking temperature in a furnace with multiple parallel passes. This cracks the heavy, long chain hydrocarbon molecules of the residual oil into coker gas oil and petroleum coke. [1] [2] [3]
Precipitation fouling is a very common problem in boilers and heat exchangers operating with hard water and often results in limescale. Through changes in temperature, or solvent evaporation or degasification , the concentration of salts may exceed the saturation , leading to a precipitation of solids (usually crystals).
Hydraulic fracturing [a] is a well stimulation technique involving the fracturing of formations in bedrock by a pressurized liquid. The process involves the high-pressure injection of "fracking fluid" (primarily water, containing sand or other proppants suspended with the aid of thickening agents) into a wellbore to create cracks in the deep rock formations through which natural gas, petroleum ...
Hydrotreated vegetable oil (HVO) is a biofuel made by the hydrocracking or hydrogenation of vegetable oil. Hydrocracking breaks big molecules into smaller ones using hydrogen while hydrogenation adds hydrogen to molecules. These methods can be used to create substitutes for gasoline, diesel, propane, kerosene and other chemical feedstock.
An industrial wastewater treatment plant may include one or more of the following rather than the conventional treatment sequence of sewage treatment plants: An API oil-water separator, for removing separate phase oil from wastewater. [43]: 180 A clarifier, for removing solids from wastewater. [44]: 41–15
The dry-sump system uses two or more oil pumps and a separate oil reservoir, as opposed to a conventional wet-sump system, which uses only the main sump (U.S.: oil pan) below the engine and a single pump. A dry-sump engine requires a pressure relief valve to regulate negative pressure inside the engine, so internal seals are not inverted.