Search results
Results From The WOW.Com Content Network
Since we have shown that the neutral current is zero we can see that removing the neutral core will have no effect on the circuit, provided the system is balanced. Such connections are generally used only when the load on the three phases is part of the same piece of equipment (for example a three-phase motor), as otherwise switching loads and ...
The volt-ampere (SI symbol: VA, [1] sometimes V⋅A or V A) is the unit of measurement for apparent power in an electrical circuit. It is the product of the root mean square voltage (in volts) and the root mean square current (in amperes). [2] Volt-amperes are usually used for analyzing alternating current (AC) circuits.
Decibel (dB) calculation; True RMS conversion; Extending the dynamic range of other circuits, used for: Automatic gain control of transmit power in radio frequency circuits; Scaling a large dynamic range sensor (e.g. from a photodiode [2]) into a linear voltage scale for an analog-to-digital converter with limited resolution [1]
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active device or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage (voltage gain), current (current gain) or electric power (power ...
An operational amplifier is an amplifier circuit which typically has very high open loop gain and differential inputs. Op amps have become very widely used as standardized "gain blocks" in circuits due to their versatility; their gain, bandwidth and other characteristics can be controlled by feedback through an external circuit. Though the term ...
The op-amp inverting amplifier is a typical circuit, with parallel negative feedback, based on the Miller theorem, where the op-amp differential input impedance is apparently decreased to zero Zeroed impedance uses an inverting (usually op-amp) amplifier with enormously high gain A v → ∞ {\displaystyle A_{v}\to \infty } .
Charge amplifiers are usually constructed using an operational amplifier or other high gain semiconductor circuit with a negative feedback capacitor C f. Into the inverting node flow the input charge signal q in and the feedback charge q f from the output. According to Kirchhoff's circuit laws they compensate each other.