Search results
Results From The WOW.Com Content Network
6in4, sometimes referred to as SIT, [a] is an IPv6 transition mechanism for migrating from Internet Protocol version 4 (IPv4) to IPv6. It is a tunneling protocol that encapsulates IPv6 packets on specially configured IPv4 links according to the specifications of RFC 4213. The IP protocol number for 6in4 is 41, per IANA reservation. [1]
An IPv6 network uses an address block that is a contiguous group of IPv6 addresses of a size that is a power of two. The leading set of bits of the addresses are identical for all hosts in a given network, and are called the network's address or routing prefix. Network address ranges are written in CIDR notation.
IPv6 implements the Neighbor Discovery Protocol (NDP, ND) in the link layer, which relies on ICMPv6 and multicast transmission. [5]: 210 IPv6 hosts verify the uniqueness of their IPv6 addresses in a local area network (LAN) by sending a neighbor solicitation message asking for the link-layer address of the IP address. If any other host in the ...
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
To allow a 6to4 host to communicate with the native IPv6 Internet, it must have its IPv6 default gateway set to a 6to4 address which contains the IPv4 address of a 6to4 relay router. To avoid the need for users to set this up manually, the anycast address 192.88.99.1 used to be allocated. [4]
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
Since it would not be practical to manually provision networks at scale, in IPv6 networking, DHCPv6 prefix delegation (RFC 3633; RFC 8415 § 6.3) is used to assign a network address prefix and automate configuration and provisioning of the public routable addresses for the network. In the typical case of a home network, for example, the home ...
The payload of an IPv6 packet is typically a datagram or segment of the higher-level transport layer protocol, but may be data for an internet layer (e.g., ICMPv6) or link layer (e.g., OSPF) instead. IPv6 packets are typically transmitted over the link layer (i.e., over Ethernet or Wi-Fi), which encapsulates each packet in a frame.