Search results
Results From The WOW.Com Content Network
Motorcycle braking systems have varied throughout time, as motorcycles evolved from bicycles with an engine attached, to the 220 mph (350 km/h) prototype motorcycles seen racing in MotoGP. Most systems work by converting kinetic energy into thermal energy (heat) by friction.
The 165 cc, air-cooled, flat twin two-stroke engine drove the right-hand rear wheel by chain, and a variable-speed friction drive transmission was used, giving two forwards speeds and reverse. A top speed of 30 mph was claimed. [2] A motorcycle using the same engine, also with friction drive, was also offered for £28 10 shillings.
Ixion engine on a Komet motorised bicycle, ca. 1902. This system is used, for example, to drive the spools in some tape recorders.In a typical configuration, one of the cylinders is the axle of an electric motor, say 1 mm in diameter, while the other is a disk with a hard rubber rim, say 50 mm in diameter, yielding a 1:50 mechanical advantage.
The Can-Am motorcycle operation was outsourced to Armstrong-CCM Motorcycles in 1983, with production ending in 1987. Can-Am resumed motorcycle production with a series of on-road three-wheel motorcycles, starting with the Spyder, using Rotax engines. As of 2020, there are three models: the Ryker uses the 2-cylinder 600 ACE and 3-cylinder 900 ...
A Honda Super Cub engine. The most popular motorcycle in history, with over 100 million produced. A motorcycle engine is an engine that powers a motorcycle.Motorcycle engines are typically two-stroke or four-stroke internal combustion engines, but other engine types, such as Wankels and electric motors, have been used.
When Crescent Motors moved to Britannia Works, Rolfe Street, Smethwick, Birmingham, the J.A.P engine was replaced by a water-cooled Precision or a Blumfield V-twin engine. [1] The final drive by chain was to only one of the rear wheels with the other driven by a friction plate so a differential was not needed.
This is an accepted version of this page This is the latest accepted revision, reviewed on 20 January 2025. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
S&S Cycle is an American motorcycle engine and parts engineer and manufacturer. The company was founded in 1958 by George J. Smith and Stanley Stankos in Blue Island, Illinois. [1] The company started by selling high performance pushrods for Harley-Davidson motorcycles, [2] and today they still make parts for a variety of V-Twin bikes. The ...