Ads
related to: 1 8 socket 4 drive set with 2 bolt
Search results
Results From The WOW.Com Content Network
Tamper-resistant versions with a pin in the recess are available. Metric sizes of the hex socket are defined by ISO 4762 (socket head cap screws), ISO 4026 (socket set screws with flat point), ISO 4027 (socket set screws with cone point), ISO 4028 (socket set screws with dog point), and ISO 4029 (socket set screws with cup point).
Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt.
The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...
An Easco spinner handle with a detachable 1 ⁄ 4 in (6.35 mm) socket attached. A nutdriver or nut driver is a hand tool for tightening or loosening nuts and bolts . It essentially consists of a socket attached to a shaft and cylindrical handle and is similar in appearance and use to a screwdriver . [ 1 ]
The internal-drive square socket for screws (as well as the corresponding triangular socket drive) had been conceived several decades before the invention of the Robertson screw and driver. An earlier patent covering both square-socket- and triangle-socket -drive wood screws, U.S. patent 161,390 , was issued to Allan Cummings of New York City ...
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...