Ads
related to: what is a 4 bolt main engine for sale
Search results
Results From The WOW.Com Content Network
The connecting rod was also 400 specific being 5.565 in (141.4 mm) as opposed to the 5.7 in (144.8 mm) rod used in all other small-block Chevrolet engines. The 400 was made in 4-bolt main journal from 1970 to 1972 and in 2-bolt main journal from 1973 to 1979.
The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 engines had larger ports and valves than ...
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
It had 2-bolt main bearing caps in 1969, but went to a block similar to the Ram Air IV's in 1969 that was drilled for 4-bolt main bearing caps (but used a cast crank and cast rods). In 1970 the casting number #9799914 Ram Air 400 4-bolt main block also used the 4-bolt main caps on Ram Air applications.
All 4.6 L 4-valve engines featured aluminum engine blocks with 6-bolt main bearing caps, the only exception being the 2003–2004 SVT Cobra which had a 4-bolt main cast iron block. The 1999 and earlier engines featured an aluminum block cast in Italy by Fiat subsidiary Teksid S.p.A. Since 1996, all of the 4.6 L 4-valve engines manufactured for ...