When.com Web Search

  1. Ads

    related to: header collector gasket

Search results

  1. Results From The WOW.Com Content Network
  2. Exhaust manifold - Wikipedia

    en.wikipedia.org/wiki/Exhaust_manifold

    Many headers are also resonance tuned, to utilize the low-pressure reflected wave rarefaction pulse which can help scavenging the combustion chamber during valve overlap. This pulse is created in all exhaust systems each time a change in density occurs, such as when exhaust merges into the collector.

  3. Head gasket - Wikipedia

    en.wikipedia.org/wiki/Head_gasket

    A leak in the head gasket - often called a "blown head gasket" - can result in a leak of coolant, the combustion gasses, or both. Blue smoke from the exhaust suggests that excess oil is entering the combustion chambers (although there are other possible causes than a head gasket leak). White smoke from the exhaust suggests that coolant is ...

  4. Exhaust gas temperature gauge - Wikipedia

    en.wikipedia.org/wiki/Exhaust_gas_temperature_gauge

    The hottest cylinder-head temperatures (CHT) and highest internal cylinder pressures occur around 50 °F (28 °C) rich of peak EGT, and risk predetonation, making it essential to avoid that range, and operate either lean of peak EGT or richer than 100 °F (56 °C) rich of peak EGT.

  5. Chevrolet small-block engine (first- and second-generation)

    en.wikipedia.org/wiki/Chevrolet_small-block...

    The coil-in-cap HEI distributor was retired, and an all-new electronic distributor design was used. The intake manifold to head bolt pattern was redesigned to improve gasket integrity—four of the center intake manifold bolts were drilled at 72° instead of 90° for the cast iron cylinder heads. Changes to the valve covers were also made.

  6. Toyota S engine - Wikipedia

    en.wikipedia.org/wiki/Toyota_S_engine

    For 2001 Toyota started fitting factory MLS (multi-layer steel) head gaskets and other metal gaskets layered with Viton to engines, including the 5S-FE. MLS head gaskets require cylinder head and cylinder block resurfacing on older engines to ensure proper sealing; consequently, the MLS head gasket did not supersede the old composite head gasket.

  7. Ball-peen hammer - Wikipedia

    en.wikipedia.org/wiki/Ball-peen_hammer

    It can also be used to make gaskets for mating surfaces: a suitable gasket material is held over the surface that needs a gasket, and the operator lightly taps around the edges of the mating surface to perforate the gasket material. [6] A. Ball-peen hammer B. Straight-peen hammer C. Cross-peen hammer Example of a hard-faced ball-peen hammer