Ads
related to: dynamic vs static wheel balancing
Search results
Results From The WOW.Com Content Network
Tire balance is measured in factories and repair shops by two methods: with static balancers and with dynamic balancers. Tires with large unbalances are downgraded or rejected. When tires are fitted to wheels at the point of sale, they are measured again on a balancing machine , and correction weights are applied to counteract their combined ...
This is seen when a bicycle wheel gets a buckled rim. The wheel will not rotate to a preferred position but because some rim mass is offset there is a wobbling couple leading to a dynamic vibration. If the spokes on this wheel cannot be adjusted to center the rim, an alternative method is used to provide dynamic balance. [2]
A static balance (sometimes called a force balance [2] [3]) occurs when the inertial axis of a rotating mass is displaced from and parallel to the axis of rotation.Static unbalances can occur more frequently in disk-shaped rotors because the thin geometric profile of the disk allows for an uneven distribution of mass with an inertial axis that is nearly parallel to the axis of rotation.
The Merrill Wheel-Balancing System was the world's first electronic dynamic wheel-balancing system. It was invented in 1945 by Marcellus Merrill at the Merrill Engineering Laboratories, 2390 South Tejon Street, Englewood, Colorado , and is now recorded on the list of IEEE Milestones in electronic engineering [ 1 ] and as an American Society of ...
Two-plane, or dynamic, balancing of a locomotive wheel set is known as cross-balancing. [11] Cross-balancing was not recommended by the American Railway Association until 1931. Up to that time only static balancing was done in America, although builders included cross-balancing for export locomotives when specified.
The advantages of using a static balancer are speed and price. However a static balancer can only correct in one plane, so its accuracy is limited. A blade balancing machine attempts to balance a part in assembly, so minimal correction is required later on. Blade mass balancing is typically done for short blades, while long blades may require ...
Under front wheel braking, the lower coefficient of friction may cause the front wheel to skid which often results in a loss of balance. [93] Front flat tire. Braking a wheel with a flat tire can cause the tire to come off the rim which greatly reduces friction and, in the case of a front wheel, result in a loss of balance. [93]
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...