Search results
Results From The WOW.Com Content Network
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
Snap, [6] or jounce, [2] is the fourth derivative of the position vector with respect to time, or the rate of change of the jerk with respect to time. [4] Equivalently, it is the second derivative of acceleration or the third derivative of velocity, and is defined by any of the following equivalent expressions: = ȷ = = =.
Jitter is often measured as a fraction of UI. For example, jitter of 0.01 UI is jitter that moves a signal edge by 1% of the UI duration. The widespread use of UI in jitter measurements comes from the need to apply the same requirements or results to cases of different symbol rates. This can be d
Electromagnetic (e.g. radio or light) waves are conceptually pure single frequency phenomena while pulses may be mathematically thought of as composed of a number of pure frequencies that sum and nullify in interactions that create a pulse train of the specific amplitudes, PRRs, base frequencies, phase characteristics, et cetera (See Fourier Analysis).
Position vectors r and r′ used in the calculation. Retarded time t r or t′ is calculated with a "speed-distance-time" calculation for EM fields.. If the EM field is radiated at position vector r′ (within the source charge distribution), and an observer at position r measures the EM field at time t, the time delay for the field to travel from the charge distribution to the observer is |r ...
It is used to specify clock stability requirements in telecommunications standards. [1] MTIE measurements can be used to detect clock instability that can cause data loss on a communications channel. [ 2 ]
The most straightforward scheme uses a digital counter and a free-running crystal oscillator to time intervals with 1-clock ambiguity, resulting in output edge jitter of one clock period peak-to-peak relative to an asynchronous trigger. This technique is used in the Quantum Composers and Berkeley Nucleonics instruments.
Propagation delay timing diagram of a NOT gate A full adder has an overall gate delay of 3 logic gates from the inputs A and B to the carry output C out shown in red.. Logic gates can have a gate delay ranging from picoseconds to more than 10 nanoseconds, depending on the technology being used. [1]