When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. IPv6 deployment - Wikipedia

    en.wikipedia.org/wiki/IPv6_deployment

    [158] [159] Customers are given a /128 via DHCP-ND unless they register their DUID in which case they receive a /56 – using a static configuration results in a single /64. According to information on telecompaper.com, [160] UPC Hungary will start deploying IPv6 in mid-2013, finishing it in 2013. The plan has not materialized until the end of ...

  3. IPv6 rapid deployment - Wikipedia

    en.wikipedia.org/wiki/IPv6_rapid_deployment

    6rd is a mechanism to facilitate IPv6 rapid deployment across IPv4 infrastructures of Internet service providers (ISPs).. The protocol is derived from 6to4, a preexisting mechanism to transfer IPv6 packets over the IPv4 network, with the significant change that it operates entirely within the end-user's ISP network, thus avoiding the major architectural problems inherent in the design of 6to4.

  4. Teredo tunneling - Wikipedia

    en.wikipedia.org/wiki/Teredo_tunneling

    Teredo routes these datagrams on the IPv4 Internet and through NAT devices. Teredo nodes elsewhere on the IPv6 network (called Teredo relays) receive the packets, un-encapsulate them, and pass them on. Teredo is a temporary measure. In the long term, all IPv6 hosts should use native IPv6 connectivity.

  5. 6to4 - Wikipedia

    en.wikipedia.org/wiki/6to4

    There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later ...

  6. DHCPv6 - Wikipedia

    en.wikipedia.org/wiki/DHCPv6

    The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.

  7. Static Context Header Compression - Wikipedia

    en.wikipedia.org/wiki/Static_Context_Header...

    Static Context Header Compression (SCHC) is a standard compression and fragmentation mechanism defined in the IPv6 over LPWAN working group at the IETF. It offers compression and fragmentation of IPv6 / UDP / CoAP packets to allow their transmission over the Low-Power Wide-Area Networks (LPWAN) .

  8. Static routing - Wikipedia

    en.wikipedia.org/wiki/Static_routing

    Static routes, connected routes, and routes from dynamic configuration protocols can be redistributed by dynamic routing protocols. For instance, a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network. [4] By using the metric to ...

  9. IPv6 address - Wikipedia

    en.wikipedia.org/wiki/IPv6_address

    An Internet Protocol version 6 address (IPv6 address) is a numeric label that is used to identify and locate a network interface of a computer or a network node participating in a computer network using IPv6. IP addresses are included in the packet header to indicate the source and the destination of each packet.