Search results
Results From The WOW.Com Content Network
In the merge sort algorithm, this subroutine is typically used to merge two sub-arrays A[lo..mid], A[mid+1..hi] of a single array A. This can be done by copying the sub-arrays into a temporary array, then applying the merge algorithm above. [1] The allocation of a temporary array can be avoided, but at the expense of speed and programming ease.
Timsort is a hybrid, stable sorting algorithm, derived from merge sort and insertion sort, designed to perform well on many kinds of real-world data.It was implemented by Tim Peters in 2002 for use in the Python programming language.
Low-density parity-check (LDPC) codes are a class of highly efficient linear block codes made from many single parity check (SPC) codes. They can provide performance very close to the channel capacity (the theoretical maximum) using an iterated soft-decision decoding approach, at linear time complexity in terms of their block length.
Merge-insertion sort also performs fewer comparisons than the sorting numbers, which count the comparisons made by binary insertion sort or merge sort in the worst case. The sorting numbers fluctuate between n log 2 n − 0.915 n {\displaystyle n\log _{2}n-0.915n} and n log 2 n − n {\displaystyle n\log _{2}n-n} , with the same leading ...
A cut-through switch will forward corrupted frames, whereas a store and forward switch will drop them. [5] Fragment free is a variation on cut-through switching that partially addresses this problem by assuring that collision fragments are not forwarded. Fragment free will hold the frame until the first 64 bytes are read from the source to ...
Weave merge was apparently used by the commercial revision control tool BitKeeper and can handle some of the problem cases where a three-way merge produces wrong or bad results. It is also one of the merge options of the GNU Bazaar revision control tool, and is used in Codeville. [citation needed]
The transmission rate will be increased by the slow-start algorithm until either a packet loss is detected, the receiver's advertised window (rwnd) becomes the limiting factor, or slow start threshold (ssthresh) is reached, which is used to determine whether the slow start or congestion avoidance algorithm is used, a value set to limit slow start.
In computer science, merge sort (also commonly spelled as mergesort and as merge-sort [2]) is an efficient, general-purpose, and comparison-based sorting algorithm.Most implementations produce a stable sort, which means that the relative order of equal elements is the same in the input and output.