Ads
related to: sliding door end pull switch kit
Search results
Results From The WOW.Com Content Network
Along with Darrin's trademark fender line, the Kaiser Darrin had entry doors that, instead of being hinged to open outward, slid on tracks into the front fender wells behind the front wheels. Fueled by Darrin's dislike for conventional doors, the designer had taken out a patent on the sliding auto door concept in 1946. [7]
Early generator interlock kits consisted of two sliding steel or plastic (depending on the brand) plates held together by three bolts and installed on the front cover of the home's breaker panel, however, some models made by Eaton (formerly Cutler-Hammer) and Siemens for panels manufactured by them install on the adjacent circuit breakers themselves and consist of a sliding arm for breakers ...
The electric overhead garage door opener was invented by C.G. Johnson in 1926 in Hartford City, Indiana. [1] Electric Garage Door openers did not become popular until Era Meter Company of Chicago offered one after World War II where the overhead garage door could be opened via a key pad located on a post at the end of the driveway or a switch inside the garage.
Available as a two-door Wrangler or four-door Wrangler Unlimited, the Rubicon X is a version of Rubicon with electronic-locking front and rear Dana 44 axles, Rock-Trac transfer case with a "4-Low" ratio of 4:1, 4.10 front/rear axle ratio Tru-Lok locking differentials, six-speed manual transmission, BF Goodrich KM 255/75R17 tires, 17-inch ...
Two different wheelbase lengths were offered as well as dual sliding doors. The base model (only offered for 1997) was the only model to offer short-wheelbase and a driver side sliding door being only optional, when all the other trim levels of the Silhouette were in long-wheelbase extended version and offered a standard driver side sliding door.
The operator is placed in the space above the sliding door. An electric motor, geared down to get a lower speed and a higher torque, drives a pulley at one end of a belt. The door is clamped to the belt. To open the door, the motor turns the pulley, which in turn turns the belt, which in turn drags the door. To close the door, the reverse occurs.