Ads
related to: th400 transmission cooling lines from trans to radiator motor system diagram
Search results
Results From The WOW.Com Content Network
Transmission fluid cooler lines on the 700R4 the bottom fitting on the right side of the transmission is the "out" line to the cooler and the top fitting is for the return line from the cooler. These fittings are .25 in (6.4 mm) pipe thread, and can include an adapter from the factory for threaded steel lines in a SAE size. 4L60Es manufactured ...
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
Designed for longitudinal engine configurations, the series included 4 forward gears. It was the 4-speed electronically commanded evolution of the 3-speed Turbo-Hydramatic 400, first produced in October 1963. 4L80-Es were optioned only in Chevrolet/GMC pickups, vans, and commercial vehicles, and the Hummer H1.
Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...
This was a later model of the 125 that debuted for 1982 and included a torque converter clutch or TCC. The TCC acts similar to a clutch in a manual transmission vehicle, in that at speeds above 35 MPH a combination of engine vacuum- and temperature-sensing valves, and a dedicated brake switch - and in later models an ECU - activated a solenoid which engaged a clutch physically locking the ...
Some engines have an oil cooler, a separate small radiator to cool the engine oil. Cars with an automatic transmission often have extra connections to the radiator, allowing the transmission fluid to transfer its heat to the coolant in the radiator. These may be either oil-air radiators, as for a smaller version of the main radiator.
Optional transmissions during the first-generation model run included the two-speed "Powerglide" automatic transmission, and a four-speed manual, available with any engine. [10] A three-speed "Turbo Hydra-Matic 350" automatic became available on most V8s starting in 1968. [11] The optional automatic for SS 396 cars was the three-speed Turbo 400 ...
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.