Search results
Results From The WOW.Com Content Network
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...
There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs. The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles.
The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes. [ 1 ] [ 10 ] TAK-4 independent suspension system accepts various spring mediums, but the vast majority of systems supplied by Oshkosh to date have been fitted ...
1st Generation Dodge Cummins trucks with non-OD transmissions are equipped with 3.07:1 "Dana 61" front axles with unique differential housings and carriers with extra clearance for the very large pinion gear. They can be easily "converted" to 3.54:1 gearing by replacing the carrier. Carrier break: 3.54:1 - 4.10:1 and 4.56:1 - 7.17:1
A unique quality of the Dana 50 axle is the lack of variation in both TTB and Solid axle versions, which simplifies repairs and upgrades. There were no carrier breaks and only one spline count (30 spline). Gross axle weight ratings were lowered by Ford for safety and tire reasons. Dana 50 TTB from a 1996 F-250
All Dana 70 rear axles are full floating and typically have a gross axle rating of 7,500 lb (3,400 kg). The Dana 70 rear axle was first used in the Dodge W300 in 1958. The Dana 70 started out using 10 spline pinions and 23 spline axle shafts. The later, more current, Dana 70 axles use 29 spline pinions and 32 or 35 spline axle shafts.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
The underside view shows the arrangement of the 18 tires (wheels). Shown in blue in the underside view are the axles, drive shaft, and differentials. The legend for labeled parts of the truck is as follows: tractor unit; semi-trailer (detachable) engine compartment; cabin; sleeper (not present in all trucks) air dam; fuel tanks; fifth-wheel ...