Search results
Results From The WOW.Com Content Network
For a small amount of entrained gas in a drilling fluid, the degasser can play a major role of removing small bubbles that a liquid film has enveloped and entrapped. [1] In order for it to be released and break out the air and gas such as methane, H 2 S and CO 2 from the mud to the surface, the drilling fluid must pass through a degassing technique, and it can be accomplished by the equipment ...
Hydrocyclones are a type of cyclonic separators that separate product phases mainly on basis of differences in gravity with aqueous solutions as the primary feed fluid. As opposed to dry or dust cyclones, which separate solids from gasses, hydrocyclones separate solids or different phase fluids from the bulk fluid.
Brine treatment is commonly encountered when treating cooling tower blowdown, produced water from steam-assisted gravity drainage (SAGD), produced water from natural gas extraction such as coal seam gas, frac flowback water, acid mine or acid rock drainage, reverse osmosis reject, chlor-alkali wastewater, pulp and paper mill effluent, and waste ...
A fluid or water deprivation test is a medical test [1] which can be used to determine whether the patient has diabetes insipidus as opposed to other causes of polydipsia (a condition of excessive thirst that causes an excessive intake of water). The patient is required, for a prolonged period, to forgo intake of water completely, to determine ...
In a conical system, as the rotating flow moves towards the narrow end of the cyclone, the rotational radius of the stream is reduced, thus separating smaller and smaller particles. The cyclone geometry, together with volumetric flow rate, defines the cut point of the cyclone. This is the size of particle that will be removed from the stream ...
Installation of a hydrodynamic separator along an Arizona highway. In civil engineering (specifically hydraulic engineering), a hydrodynamic separator (HDS), also called a swirl separator, is a stormwater management device that uses cyclonic separation to control water pollution.
The spray drying technique was first described in 1860 with the first spray dryer instrument patented by Samuel Percy in 1872. [citation needed] With time, the spray drying method grew in popularity, at first mainly for milk production in the 1920s and during World War II, when there was a need to reduce the weight and volume of food and other materials.
In practice, doses of doubly labeled water for metabolic work are prepared by simply mixing a dose of deuterium oxide (heavy water) (90 to 99%) with a second dose of H 2 18 O, which is water which has been separately enriched with 18 O (though usually not to a high level, since doing this would be expensive, and unnecessary for this use), but ...