Search results
Results From The WOW.Com Content Network
A distributor consists of a rotating arm ('rotor') that is attached to the top of a rotating 'distributor shaft'. The rotor constantly receives high-voltage electricity from an ignition coil via brushes at the centre of the rotor. As the rotor spins, its tip passes close to (but does not touch) the output contacts for each cylinder.
The large-journal connecting rods were thicker (heavier) and used 3 ⁄ 8 in (9.5 mm) diameter cap-bolts to replace the small-journal's 11/32. 1968 blocks were made in 2-bolt and 4-bolt versions with the 4-bolt center-three main caps each fastened by two additional bolts which were supported by the addition of thicker crankcase main-web bulkheads.
Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.
A long block does not include the fuel system, electrical, intake, and exhaust components, as well as other components. A long block may include the balancer/damper, timing cover, oil pan and valve covers. [5] A long block engine replacement typically requires swapping out parts from the original engine to the long block.
The new logo formally adopts the Small Block name for the engines. The fifth generation of the iconic GM small block engine family features the same cam-in-block architecture and 4.4 in (110 mm) bore centers (the distance between the centers of each cylinder) that were born with the original small block in 1954.
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
To reduce mass, the engines are compact in all directions, made almost entirely of aluminum, and feature composite intake manifolds. This removes 44 pounds (20 kg) from the existing 1.4-liter turbo in the Cruze and makes it 8 pounds (4 kg) lighter than the 1.4-liter VW turbo. GM says this engine weighs 216 pounds (98 kg), ready for installation.
To do so, manifold injection systems have at least one way to measure the amount of air that is currently being sucked into the engine. In mechanically controlled systems with a fuel distributor, a vacuum-driven piston directly connected to the control rack is used, whereas electronically controlled manifold injection systems typically use an ...