Search results
Results From The WOW.Com Content Network
The relative change in resistance (temperature coefficient of resistance) varies only slightly over the useful range of the sensor. [ citation needed ] Platinum was proposed by Sir William Siemens as an element for a resistance temperature detector at the Bakerian lecture in 1871: [ 2 ] it is a noble metal and has the most stable resistance ...
An NTC is commonly used as a temperature sensor, or in series with a circuit as an inrush current limiter. With PTC thermistors, resistance increases as temperature rises; usually because of increased thermal lattice agitations, particularly those of impurities and imperfections. PTC thermistors are commonly installed in series with a circuit ...
The output voltage from the thermopile, ΔV, is directly proportional to the temperature differential, ΔT or T 1 - T 2, across the thermal resistance layer and number of thermocouple junction pairs. The thermopile voltage output is also directly proportional to the heat flux, q" , through the thermal resistance layer.
The Resistance Temperature Detector is nearly always refered to in industry as an RTD - many folk don't even know it is an acronym. Resistance thermometer is an equivalent name for the same device. Converting the two into a common reference makes good sense. These are very commonly used for industrial temperature measurements.
A dc bias current is applied to the resistor to raise its temperature via Joule heating, such that the resistance is matched to the waveguide characteristic impedance. After applying microwave power, the bias current is reduced to return the bolometer to its resistance in the absence of microwave power.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
The Callendar–Van Dusen equation is an equation that describes the relationship between resistance (R) and temperature (T) of platinum resistance thermometers (RTD).. As commonly used for commercial applications of RTD thermometers, the relationship between resistance and temperature is given by the following equations.
This page was last edited on 7 September 2006, at 06:29 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.