When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Camlock (electrical) - Wikipedia

   en.wikipedia.org/wiki/Camlock_(electrical)

   Each camlock connector carries a single phase, pole, or conductor; multiple camlock connectors will be used to make a complete electrical supply or circuit. The most common form is the 16 series, rated at 400 amperes with 105 °C terminations. Also in common use is the 15 series (mini-cam), rated at 150 amperes.

3. NEMA connector - Wikipedia

   en.wikipedia.org/wiki/NEMA_connector

   NEMA L14 are three-pole and ground connectors rated for 125/250 V. Intended for three-pole, four-wire hot-hot-neutral-ground circuits with a nominal supply voltages of 240 or 208 V hot-to-hot and 120 V hot-to-neutral. These connectors are common on household backup generators, and on racks of power amplifiers in large audio systems.

4. Battery holder - Wikipedia

   en.wikipedia.org/wiki/Battery_holder

   Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Board to board connectors – e.g. card-edge connectors or FPGA mezzanine connectors; Twist-on wire connectors (e.g. wire nuts) – used in low-voltage power circuits for wires up to about 10 AWG; Wire wrapping – used in older circuit boards

6. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   The JST RCY-series connector is a 2.5mm-pitch and manufactured by J.S.T. Mfg. Co., Ltd. [8] It is known in radio control circles as the battery eliminator circuit (BEC) or P connector. JST also produces other types of connectors that are used in R/C and hobby electronics. [9]

7. Battery terminal - Wikipedia

   en.wikipedia.org/wiki/Battery_terminal

   Larger external battery packs use a variety of connectors, including the Anderson Powerpole MultiPole series (as used by Tripp Lite), which are color-coded and keyed for specific voltages. Very large batteries as installed in battery rooms such as are found in datacenters use bolted connections from cell terminals to bus bars or flexible cables .