Search results
Results From The WOW.Com Content Network
A more recent industrial standard is the European EN 13501-1 - Fire classification of construction products and building elements—which roughly replaces A2 with A2/B, B1 with C, B2 with D/E and B3 with F. B3 or F rated materials may not be used in building unless combined with another material that reduces the flammability of those materials.
EN 13501: Fire classification of construction products and building elements; EN 13537: Temperature ratings for sleeping bags; EN 13594:2002: Protective gloves for professional motorcycle riders. Requirements and test methods; EN 13595-1:2002: Protective clothing for professional motorcycle riders. Jackets, trousers and one piece or divided suits.
Class 1 goods are subdivided further into one of 6 distinct divisions, that describes the predominant explosive hazard that exists if that article was to detonate or activate while in transport or storage. These divisions are as follows: Class 1: Explosives. Division 1.1: Explosive that has a mass explosion hazard. A mass explosion is a ...
This is the rating required to protect microfilm, microfiche, and other film-based information storage media. Above 150 °F (65.5 °C) film is distorted by the heat and information is lost. A Class 150-2 Hour vault must keep the temperature below 150 °F. for at least two hours, with temperatures up to 2,000 °F. (1,093.3 °C) outside the vault.
The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B. The IEEE 315 standard contains a list of Class Designation Letters to use for electrical and electronic ...
Printed circuit board with the mark "94V-0" in the bottom-left corner. UL 94, the Standard for Safety of Flammability of Plastic Materials for Parts in Devices and Appliances testing, is a plastics flammability standard released by Underwriters Laboratories of the United States. [1]
Additionally, several of the threat levels have been increased in difficulty with the introduction of new test threats; most notably is the introduction of Class BR6, which requires the tested armor to survive three hits of 12.7×108mm B32 API. In spite of the more difficult test threats, the 16 mm (0.63 in) back-face deformation limit remains ...
Class I, Division 2 or Zone 2 classified locations An area where ignitable concentrations of flammable gases, vapors or liquids are not likely to exist under normal operating conditions. In this area the gas, vapor or liquids would only be present under abnormal conditions (most often leaks under abnormal conditions).