Ad
related to: convert grid reference to latitude longitude free
Search results
Results From The WOW.Com Content Network
Informally, specifying a geographic location usually means giving the location's latitude and longitude. The numerical values for latitude and longitude can occur in a number of different units or formats: [2] sexagesimal degree: degrees, minutes, and seconds : 40° 26′ 46″ N 79° 58′ 56″ W
UK places and Irish places traditionally use grid references, and a latitude /longitude system tied to an OSGB36 datum. This gives a 112 m (367 ft) difference. The NAD83 map datum is sufficiently close to WGS84 for initial use. It is best to double check on a mapping site such as WikiMapia.
The World Geographic Reference System (GEOREF) is a geocode, a grid-based method of specifying locations on the surface of the Earth. GEOREF is essentially based on the geographic system of latitude and longitude , but using a simpler and more flexible notation .
Within each 100 km square, a numerical grid reference is used. Since the Eastings and Northings are one kilometre apart, a combination of a Northing and an Easting will give a four-digit grid reference describing a one-kilometre square on the ground. The convention is the grid reference numbers call out the lower-left corner of the desired square.
Plus codes are derived from latitude and longitude coordinates, so they already exist everywhere. [5] They are similar in length to a telephone number (e.g., 849VCWC8+R9) but can often be shortened to only four or six digits when combined with a locality (e.g., CWC8+R9, Mountain View, California). Locations close to each other have similar codes.
The intersection of a UTM zone and a latitude band is (normally) a 6° × 8° polygon called a grid zone, whose designation in MGRS is formed by the zone number (one or two digits – the number for zones 1 to 9 is just a single digit, according to the example in DMA TM 8358.1, Section 3-2, [1] Figure 7), followed by the latitude band letter ...
The reverse conversion is harder: given X-Y-Z can immediately get longitude, but no closed formula for latitude and height exists. See "Geodetic system." Using Bowring's formula in 1976 Survey Review the first iteration gives latitude correct within 10-11 degree as long as the point is within 10,000 meters above or 5,000 meters below the ellipsoid.
A geographic coordinate system (GCS) is a spherical or geodetic coordinate system for measuring and communicating positions directly on Earth as latitude and longitude. [1] It is the simplest, oldest and most widely used type of the various spatial reference systems that are in use, and forms the basis for most others.