Search results
Results From The WOW.Com Content Network
Brake cleaner, often also called parts cleaner, is a mostly colorless cleaning agent, mainly used for cleaning the brake disks, the engine compartment and underfloor of motor vehicles. An important feature is that the brake cleaner leaves no residue after the solvents evaporate .
Front cover – The M16A1 Rifle – Operation and Preventive Maintenance by Will Eisner, issued to American soldiers in the Vietnam War. An inadequately maintained firearm will often accumulate excessive fouling and dirt within the barrel and receiver, which not only can clog up the rifling and decrease the firearm's accuracy and precision, but can also interfere with the proper operation of ...
Figure 1 - Baffle spray scrubber. Baffle spray scrubbers are a technology for air pollution control.They are very similar to spray towers in design and operation. However, in addition to using the energy provided by the spray nozzles, baffles are added to allow the gas stream to atomize some liquid as it passes over them.
Cosmoline is also frequently applied to automotive disc brake rotors at the factory, to prevent corrosion inside the box before the rotor is placed into service on a vehicle. It is easily removed by spraying brake cleaner on the braking surfaces of the rotor although brake pad manufacturers do not recommend this technique.
It was first invented in 1955 by H.B. Sargent, R.M. Poorman and H. Lamprey and is applied to a component using a specifically designed detonation gun (D-gun). The component being sprayed must be prepared correctly by removing all surface oils, greases, debris and roughing up the surface in order to achieve a strongly bonded detonation spray ...
These can be removed very well by a wet scrubber. [5] Removal efficiency of pollutants is improved by increasing residence time in the scrubber or by the increase of surface area of the scrubber solution by the use of a spray nozzle, packed towers or an aspirator.
Another mechanically aided scrubber, the induced-spray, consists of a whirling rotor submerged in a pool of liquid. The whirling rotor produces a fine droplet spray. By moving the process gas through the spray, particles and gaseous pollutants can subsequently be collected. Figure 2 shows an induced-spray scrubber that uses a vertical-spray rotor.
Each of these steps may take place in its own bath, chamber, or, in case of spray cleaning, in its own zone (line or multi-chamber equipment). But often these steps may have a single chamber into which the respective media are pumped in (single chamber plant). Cleaning media plays an important role as it removes the contaminants from the substrate.