Ads
related to: chimney duct design manual
Search results
Results From The WOW.Com Content Network
Round duct is made using a continuous spiral forming machine which can make round duct in nearly any diameter when using the right forming die and to any length to suit, but the most common stock sizes range evenly from 4" to 24" (10-60 cm) with 6"-12" (15-30 cm) being most commonly used. Stock pipe is usually sold in 10' (300 cm) joints.
A seven-flue chimney in a four-storey Georgian house in London, showing alternative methods of sweeping. A flue is a duct, pipe, or opening in a chimney for conveying exhaust gases from a fireplace, furnace, water heater, boiler, or generator to the outdoors. Historically the term flue meant the chimney itself. [1]
A major consideration of duct design is to minimize duct pressure losses, turbulence, as poor duct geometry, increases turbulence, and increases plant electrical usage. Round duct work suction pressure collapse, in ducts over 6 feet in diameter, is prevented with rings at supports, and roughly 3 diameter centers.
The stack effect or chimney effect is the movement of air into and out of buildings through unsealed openings, chimneys, flue-gas stacks, or other purposefully designed openings or containers, resulting from air buoyancy. Buoyancy occurs due to a difference in indoor-to-outdoor air density resulting from temperature and moisture differences ...
An H-style cap is a chimney top constructed from chimney pipes shaped like the letter H. It is an age-old method of regulating draft in situations where prevailing winds or turbulences cause downdraft and back-puffing. Although the H cap has a distinct advantage over most other downdraft caps, it fell out of favor because of its bulky design.
In this design the whole air preheater casing is supported on the boiler supporting structure itself with necessary expansion joints in the ducting. The vertical rotor is supported on thrust bearings at the lower end and has an oil bath lubrication, cooled by water circulating in coils inside the oil bath.
The ASHRAE Handbook has had a variety of titles. [5] It began in 1922 as the ASH&VE Guide.In 1973 it became the ASHRAE Handbook, and in 1985 separate publication of inch-pound and international system units versions of the volumes began.
A damper is a valve or plate that stops or regulates the flow of air inside a duct, chimney, VAV box, air handler, or other air-handling equipment. A damper may be used to cut off central air conditioning (heating or cooling) to an unused room, or to regulate it for room-by-room temperature and climate control - for example, in the case of ...