Search results
Results From The WOW.Com Content Network
Snubbers allow for free thermal movement of a component during regular conditions, but restrain the component in irregular conditions. [6] A hydraulic snubber allows for pipe deflection under normal operating conditions. When subjected to an impulse load, the snubber becomes activated and acts as a restraint in order to restrict pipe movement. [7]
This base design is supplemented by a snubber circuit consisting of a few passive components. [5] It prevents the occurrence of simultaneously high values of voltage and current, and hence high power dissipation values, during the switching process. All switching processes therefore take place in a "soft" manner.
A smaller unit which simulates a complete unit or element in an electrical test, without reducing the severity of the electrical, thermal or mechanical conditions. [v] multi-connected converter A converter consisting of two or more converter units parallel connected or series connected or both, each of which is an operative converter of its own.
A mechanical snubber is a mechanical device designed to protect components from excess shock or sway caused by seismic disturbances or other transient forces. [1] During normal operating conditions, the snubber allows for movement in tension and compression. [2] When an impulse event occurs, the snubber becomes activated and acts as a restraint ...
A snubbing rigup is a very tall structure. It consists of a hydraulically powered snubbing unit, which provides the force on a pipe, above a string of multi-layered pressure control components.
Hydraulic snubbers are used on piping systems when restrained thermal movement is allowed. [5] Mechanical snubbers operate on the standards of restricting acceleration of any pipe movements to a threshold of 0.2 g's, which is the maximum acceleration that the snubber will permit the piping to see. [6]
Substantial snubber circuits are added around the device to limit the rise of voltage at turn off. Resetting the snubber circuit usually places a minimum on-time requirement on GTO-based circuits. The minimum on- and off-time is handled in DC motor chopper circuits by using a variable switching frequency at the lowest and highest duty cycle.
Alternatively, where safety allows and electrical isolation of the controller isn't necessary, one of the microcontroller's power rails may be connected to one of the mains supply. In these situations it is normal to connect the neutral terminal to the positive rail of the microcontroller's power supply, together with A1 of the triac, with A2 ...