When.com Web Search

  1. Ads

    related to: when should you replace shocks and struts

Search results

  1. Results From The WOW.Com Content Network
  2. Strut - Wikipedia

    en.wikipedia.org/wiki/Strut

    Strut is a common name in timber framing for a support or brace of scantlings lighter than a post. Frequently struts are found in roof framing from either a tie beam or a king post to a principal rafter. Struts may be vertically plumb or leaning (then called canted, raking, or angled) and may be straight or curved.

  3. Automotive suspension design process - Wikipedia

    en.wikipedia.org/wiki/Automotive_suspension...

    For both ends of the car this would include the type of spring, location of the spring, and location of the shock absorbers. For the front suspension the following need to be considered The type of suspension (MacPherson strut or double wishbone suspension) Type of steering actuator (rack and pinion or recirculating ball)

  4. Car suspension - Wikipedia

    en.wikipedia.org/wiki/Car_suspension

    Shock absorbers damp out the (otherwise simple harmonic) motions of a vehicle up and down on its springs. They must also damp out much of the wheel bounce when the unsprung weight of a wheel, hub, axle, and sometimes brakes and the differential bounces up and down on the springiness of a tire.

  5. MacPherson strut - Wikipedia

    en.wikipedia.org/wiki/MacPherson_strut

    The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.

  6. Shock absorber - Wikipedia

    en.wikipedia.org/wiki/Shock_absorber

    Unlike a shock absorber, a strut has a reinforced body and stem. Struts are subjected to multidirectional loads, while a shock absorber only damps vibration, only receiving a load along its axis. Struts and shock absorbers have a different way of attachment. Shock absorbers are mounted through rubber or urethane bushings to the frame and ...

  7. Self-levelling suspension - Wikipedia

    en.wikipedia.org/wiki/Self-levelling_suspension

    Land Rover developed a self-levelling rear suspension using the "Boge Hydromat" self-energising hydraulic strut. [13] Of similar construction to a hydraulic shock absorber the strut used the motion of the suspension travelling over bumps to pump itself back up to a pre-set height. It was sufficiently powerful to regain up to 85% of normal ride ...