Ads
related to: 6 panel closet doors sliding bedroom drawersstraitandlampworthington.andersendealer.com has been visited by 10K+ users in the past month
expertwindows.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
In the Netherlands the closet-bed, or bedstede, was in common use into the 19th century, particularly in farmhouses in the countryside. Closet-beds were closed off with a door or a curtain. One of the advantages of the closet-bed was that it could be built into the living room and closed off during the day, making a separate bedroom unnecessary.
Smooth fitting of panel and groove is critical to allow the panels to move easily, [5] and the woodworking of the sliding mechanism developed over time [6] (modern shoji can be moved with one finger). [5] Formerly, the grooves were made by dobumizo (どぶ溝), nailing strips of wood to the kamoi (lintel) and shikii (sill) beams. [6]
Chests of drawers often come in 5-, 6-, and 7-drawer varieties, with either a single or a double top drawer. The chest illustrated in this section would be described as a '5 over 2 chest-on-chest', the latter term deriving from the fact that at one time it would have been made as two separable pieces.
The mechanism is also secure, since it cannot be lifted out of its hinges. [6] Sliding doors are commonly found as store, hotel, and office entrances, used in elevators, and used as patio doors, closet doors and room dividers. [7] Sliding doors are also used in transportation, such as in vans and both overground and underground trains.
In this California kitchen, a bright green screened door brings a bit of colorful whimsy to the pantry. Inside, soda crates, enamelware bins, and more line the bracketed shelves making organizing ...
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame.