Search results
Results From The WOW.Com Content Network
{{Deg2DMS |positive decimal degrees| p =precision| sup =ms}} |p= is optional and defaults to 3. It is the number of decimal digits that the seconds are rounded to. |sup= is optional and changes the default apostrophe-format for arcminutes and arcseconds (1° 2′ 3″) to the m-s-format for arcminutes and arcseconds (1° 2 m 3 s).
Decimal degrees are an alternative to using sexagesimal degrees (degrees, minutes, and seconds - DMS notation). As with latitude and longitude, the values are bounded by ±90° and ±180° respectively. Positive latitudes are north of the equator, negative latitudes are south of the equator.
The numerical values for latitude and longitude can occur in a number of different units or formats: [2] sexagesimal degree: degrees, minutes, and seconds : 40° 26′ 46″ N 79° 58′ 56″ W; degrees and decimal minutes: 40° 26.767′ N 79° 58.933′ W; decimal degrees: +40.446 -79.982; There are 60 minutes in a degree and 60 seconds in a ...
Minutes and seconds need not be specified. If no degrees are specified then a value of zero is assumed. This template does not attempt to trap invalid values and results in this case might be undefined. The decimal precision of the result is determined by the value assigned rnd, which defaults to 7.
Degrees, minutes and seconds, when used, must each be separated by a pipe ("|"). Map datum must be WGS84 if possible (except for off-Earth bodies). Avoid excessive precision (0.0001° is <11 m, 1″ is <31 m). Maintain consistency of decimal places or minutes/seconds between latitude and longitude. Latitude (N/S) must appear before longitude (E/W).
Each degree of longitude is sub-divided into 60 minutes, each of which is divided into 60 seconds. A longitude is thus specified in sexagesimal notation as, for example, 23° 27′ 30″ E. For higher precision, the seconds are specified with a decimal fraction. An alternative representation uses degrees and minutes, and parts of a minute are ...
The decimal point is a part of the value, thus must usually be configured by the operating system. [a] Multiple locations should be represented by multiple lines. Latitude and longitude should be displayed by sexagesimal fractions (i.e. minutes and seconds). When minutes and seconds are less than ten, leading zeroes should be shown.
It is measured in degrees, minutes and seconds, or decimal degrees, north or south of the equator. For navigational purposes positions are given in degrees and decimal minutes. For instance, The Needles lighthouse is at 50°39.734′ N 001°35.500′ W. [2]