Search results
Results From The WOW.Com Content Network
ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter.
Strength depends upon material properties. The strength of a material depends on its capacity to withstand axial stress, shear stress, bending, and torsion.The strength of a material is measured in force per unit area (newtons per square millimetre or N/mm², or the equivalent megapascals or MPa in the SI system and often pounds per square inch psi in the United States Customary Units system).
The relative stiffness of the bolt and the clamped joint components do, however, determine the fraction of the external tension load that the bolt will carry and that in turn determines preload needed to prevent joint separation and by that means to reduce the range of stress the bolt experiences as the tension load is repeatedly applied.
Internal stress to a bearing through application of negative clearance is known as bearing preloading. Advantages of preloading include the following: maintain axial and radial position for accurate displacements of angular movements; increase bearing rigidity; prevent sliding or gyroscope-like movements, especially with high acceleration or ...
Mam Tor road destroyed by subsidence and shear, near Castleton, Derbyshire.. In engineering, shear strength is the strength of a material or component against the type of yield or structural failure when the material or component fails in shear.
Stress resultants are defined as integrals of stress over the thickness of a structural element. The integrals are weighted by integer powers the thickness coordinate z (or x 3). Stress resultants are so defined to represent the effect of stress as a membrane force N (zero power in z), bending moment M (power 1) on a beam or shell (structure).
In the absence of a qualifier, the term bending is ambiguous because bending can occur locally in all objects. Therefore, to make the usage of the term more precise, engineers refer to a specific object such as; the bending of rods, [2] the bending of beams, [1] the bending of plates, [3] the bending of shells [2] and so on.
Bolts are correctly torqued to maintain the friction. The shear force only becomes relevant when the bolts are not torqued. A bolt with property class 12.9 has a tensile strength of 1200 MPa (1 MPa = 1 N/mm 2 ) or 1.2 kN/mm 2 and the yield strength is 0.90 times tensile strength, 1080 MPa in this case.